SIPOS Seven Aktorik Ecotron Series User Manual

Operation instructions
SIPOS SEVEN ECOTRON
Page 16 Y070.301/EN
4 Instructions on operator control and operation
4
Instructions on operator control and operation
4�2�2 Indication of control, operation direction, end position
When illuminated or by ashing, the light emitting diodes (LEDs) indicate
■
the control type: LOCAL mode or REMOTE mode,
■
the direction (OPEN or CLOSE) during operation,
■
the end position if the actuator is in one of the end positions (OPEN or CLOSED).
The states of the LEDs (off – illuminated – ashing) are represented in the operation instructions as
follows:
LED is not illuminated (off)
LED is illuminated
LED is ashing
Arrangement of the LEDs State of the LEDs Explanation
(yellow) (green)
Both LEDs are not illuminated:
Actuator is at standstill and in mid-travel.
The CLOSE LED is ashing:
The actuator operates in CLOSE direction.
The OPEN LED is ashing:
The actuator operates in OPEN direction.
The CLOSE LED is illuminated:
The actuator is in end position CLOSED.
The OPEN LED is illuminated:
The actuator is in end position OPEN.
(yellow)
(blue)
The actuator is in “LOCAL mode”.
The actuator is in “REMOTE mode”.
(green) (red)
The LEDs indicate: "Ready" or "Fault" and
the states during commissioning. Refer to
"Status and fault signals" chapter below.

SIPOS Seven Aktorik Ecotron Series Specifications

General

Brand	SIPOS
Model	Seven Aktorik Ecotron Series
Category	Controller
Language	English