Operation instructions
SIPOS SEVEN ECOTRON
Page 4 Y070.301/EN
1 General information
1
General information
1�3 Disposal and recycling
Packaging
The packaging of our products consists of environmentally friendly materials which can easily be
separated and recycled. We use the following packaging materials: Wood-based panels (MSB/
OSB), cardboard, paper, PE foil. For the disposal of the packaging material, we recommend recy-
cling and collection centers.
Actuator
SEVEN actuators have a modular design and may therefore be easily disassembled, separated
and sorted according to materials, i.e.: electronic parts, different metals, plastics, greases and oils.
The following generally applies:
■
Collect greases and oils during disassembly. As a rule, these are substances hazardous to water
and must not be released into the environment.
■
Arrange for controlled waste disposal of the disassembled material or for separate recycling
according to materials.
■
Observe the national/local regulations for waste disposal.
1�4 Notes to the operation instructions
1�4�1 Safety instructions: Used symbols and their meanings
The following symbols, which have different meanings, are used in the operation instructions.
Non-observance of safety instructions may lead to serious injuries or damage.
Warning marks activities which, if not carried out correctly, can affect the safety of persons or
property.
Notice marks activities which have major inuence on the correct operation. Non-observance of
these notes may lead to consequential damage.
Electrostatically endangered parts are located on circuit boards which may be damaged or de-
stroyed by electrostatic discharges. If the boards need to be touched during setting, measurement
or for exchange, it must be assured that immediately before touching an electrostatic discharge
through contact with an earthed metallic surface (e.g. the housing) has taken place.
Procedure may have been performed by valve manufacturer:
If actuators are delivered mounted to a valve, this step has been done in the valve manufacturer’s
factory. The setting has to be checked during commissioning.
1�2 Transport and storage
■
The device must be supplied in sturdy packaging.
■
For transport, loop the rope around the hand wheel housing,
refer to illustration. Only use the eyes provided on the elec-
tronics unit (g. item 1) to lift the actuator's own weight.
■
Do not attach the ropes and hooks at the crank handle or
hand wheel for the purpose of lifting.
■
Store in well-ventilated, dry room
at -30 °C – +80 °C.
■
Protect against damp oors by storing on a shelf or pallet.
■
Keep connection hood/cover and cable glands as well as the
cover of the electronics unit closed.
Fig�: Transport
To Next Page
Loading...
Need help?
General
