Imaging
6-9
at this moment, all the focuses will be shifted up or down accordingly.
If select SPAN in the control window, the system will enter the span setting state; press
Value control key to change the span between focal points.
6.4.3 Setting persistence
In unfrozen state, press
T-Ball, use the touchpad to select PER on control window, then
the persistence value can be changed by pressing the
Value control key; the value will be
changed from 0 to 7 continuously.
6.4.4 Setting Smooth
In unfrozen state, you can press
T-Ball to change the Smooth value, then operate the
touchpad to select SMO in the control window. And then press Value control key to
change the Smooth value. The value will be changed from 0 to 3 continuously.
6.4.5 Setting Edge Enhancement
In unfrozen state, press
T-Ball and move the touchpad to select ENH in the control
window. Press
Value control key to change the value. The value will be changed from 0
to 4 continuously.
【Note】: Smooth and Edge Enhancement cannot be set at the same time. When one
item is set, the other is automatically set at “0”.
6.4.6 Selecting Grayscale
In B mode unfrozen state, press
T-Ball and operate the touchpad to select B_GSC in the
control window. Press Value control key to select different grayscale curves.
6.4.7 Adjusting Dynamic Range
In unfrozen state, to change dynamic range, press
T-Ball first, then operate the touchpad
to select DYN in the control window, after that, press the
Value control key to change the
dynamic range (continuously change from 35~66dB).
6.4.8 Setting M-mode Sweeping Speed
In B/M, M mode unfrozen state, to set the M image sweeping speed, press
M Speed
repeatedly, or first press T-Ball to toggle the touchpad-operated object to the control
window, and select the MSP. And then press
Value control key to set the M mode image
To Next Page
Loading...
