Maintenance, Troubleshooting, Transport and Storage
10-1
Chapter 10
Maintenance, Troubleshooting,
Transport and Storage
10.1 System Maintenance
Every time before operating the system, the user should inspect the probe cable
connector, the probe cable, the potential balance lead, and the power cord carefully to
check whether there is any separated sheath, shedding, or other signs of damage on
them. As these involve safety, special attention should be paid to these daily inspections
so as to avoid any unexpected danger due to abnormality on them.
Every time when turning the system on, the user should inspect if the power pilot lamp and
the fan in the main unit are running in good order. The keys might be inspected thoroughly
every half a year. For detailed information, please refer to Section 4.2 “Maintenance and
Inspection”.
10.2 Troubleshooting
The following table lists some failures and a number of possible causes (see Table 10-1);
the user may refer to the provided solutions for troubleshooting. If the failure cause cannot
be identified, or the troubles cannot be solved after trying the methods below, please
contact our service department for help. In order to avoid damaging the system due to
incorrect operation, it is not recommended that the user dismantle and repair the system
before getting our instructions.
To Next Page
Loading...