Imaging
6-5
finish the loading and save.
The hotkey
D can be used to delete a user-defined exam type. Press this key after
selecting an exam type to be deleted. The system will prompt whether to delete that exam
type or not. Select SET then press
Enter to confirm, or select Cancel then press Enter
to cancel deletion.
The hotkey
N is used to modify a user-defined exam type. Press this key after selecting
an exam type to be modified. An input box will appear for entering a new exam type. Press
Enter to finish entering.
The hotkey
R can be used to load the current exam type system defined parameters.
Press this key after selecting an exam type to be reloaded with parameters. The system
will prompt whether to reload that exam type parameter. Select SET then press
Enter to
confirm, or select Cancel then press
Enter to cancel loading.
The hotkey
S can be used to set the current exam type as the current applied default
exam type. Press this key after selecting an exam type to be set as the default exam type,
and a “#” will appear in front of that exam type. Each application type can only have one
default exam type.
The hotkey
U can be used to save the current image control parameter to the selected
exam type settings. The system will prompt whether to change the exam type parameters.
Select SET then press
Enter to confirm saving, or select Cancel then press Enter to
quit saving.
The hotkey
V can be used to view the image control parameter setting of a selected exam
type.
6.3 Preliminary Imaging
6.3.1 Usage of Probe and Ultrasound Coupling Gel
a) Apply adequate amount of ultrasound coupling gel to the surface of a patient’s part
to be examined and the probe.
Note: If there is air entering between the patient body and the probe, black dots
will appear on the image. In this case, apply the coupling gel once more.
To Next Page
Loading...
