Cineloop, Image Storage and Print
9-1
Chapter 9
Cineloop, Image Storage and Print
9.1 Cineloop
In B, 2B or 4B mode unfrozen state, images will be stored continuously into memory. After
the image is frozen, the stored images can be played back in frames. Operate the
touchpad will enable viewing the images in the memory saved before the image is frozen.
Operate the touchpad right will enable viewing the foremost stored images in memory, and
operate the touchpad left will enable viewing the latest stored images in memory. The
rectangular box on the upper part of the screen displays the position of the current
playback image in the total images that can be played back. In B, 2B and 4B mode,
pressing
Cine key will start image continuous cine, and the cine will be played
continuously from the positive or the negative direction according to the user preset cine
direction (see Cine Direction setup in Chapter 5); pressing
Value will change cine speed,
and pressing
Cine again will exit the continuous cine.
In 2B or 4B mode, when it is in manual single frame cine, press
Enter to select image
playback of different B-mode areas.
In B/M or M mode unfrozen state, images will be stored continuously into memory. After
the image is frozen, the stored M-mode images can be played back in line form. Operate
the touchpad left or right to change the position of the start line on the utter left of M-mode
image in all stored M-mode images. Each press of
Cine will switch between changing
10-line position or 128-line position. The rectangular box on the upper screen displays the
position of the current playback image among the total cineloop images.
9.2 Quickly Store and Recall of Image
9.2.1 Quickly Store an Image
Press
Save key may quickly store an image.
There are two selections for image storage location: Memory and Hard Disk. If Memory
is selected, the image is stored temporarily. If the memory is full, press
Save key may
overwrite the most previously stored image. When the system is rebooted, all the stored
images will be removed. If Hard Disk is selected, a new folder named after the current
date will be created in the hard disk and the image (whose file name is the storage time)
To Next Page
Loading...
