Measurement and Calculation
8-15
a) Patient Information in reports cannot be edited (except for pressing Pat Data key).
b) Gestation Age and Estimated Date of Delivery are calculated automatically based on
the result of LMP and measurement.
c) Relevant measurement result will be displayed in the report if the user does certain
measurement.
d) Placenta Grade in the OB report is selectable by pressing
Value control key.
e) The items of Shape Echoes and Inner Echoes in the prostate report can be
selected by pressing
Value control key or placing the cursor over the desired item
and press
Enter key to have the box in front of the item checked automatically.
f) The operation of annotation in report is the same as that of Text key (Doctor’s name
is not cleared when clearing report annotation).
g) Save Report: In the report screen, press
Disk to save the report in BMP or JPG
format. You can also press
Disk to reopen the saved report for review or printing, but
the report is not editable. (See Section 9.3 for further description on save or open
operation.)
8.2 Display and Clear of Meas/Calc Result
8.2.1 Display Meas/Calc Result
When an item of measurement & calculation is selected by the user, the current position
of the cursor is displayed on the image as “+” for the user to select the measuring initial
and end point. Measurement & calculation results are displayed real-time according to
user operation. While calculating or measuring, the measured point coordinate should not
be beyond the border of the measured image element. While conducting distance,
circumference/area, or items in general measurements, pressing
Dis, Area or Meas
key will enter a new measurement as above; in this case, the current measurement
results will stay on the screen. Up to 9 measuring results can be reserved for each kind of
measurement (such as distance, area/circumference, volume and time, etc.); the start
points for each kind of measurement are shown on the screen as a, b, c and so on, and
measured items of measuring results are marked with a, b, c and so on for identification.
Change display position of Meas/Calc result: In state of Calc/Meas, press
P key to shift
To Next Page
Loading...
