- 14 -
951-171-016
Version 03
EN
1. Safety instructions
regulations and the local connection con-
ditions into account.
○ Do not touch cables or electrical compo-
nents with wet or damp hands.
○ Fuses must not be bypassed. Replace
defective fuses always by fuses of the
same type.
○ Undertake drilling at non-critical, non-
load bearing parts only. Use any available
boreholes. Do not damage lines and ca-
bles when drilling.
○ Observe possible abrasion points. Protect
the parts accordingly.
○ All components used must be designed
for:
- the maximum operating pressure
- the maximum/ minimum ambient
temperature
○ No parts of the centralized lubrication
system may be subjected to torsion,
shear, or bending.
○ Check all parts prior to their usage for
contamination and clean, if necessary.
○ Lubricant lines should be primed with
lubricant prior to installation. This makes
the subsequent ventilation of the system
easier.
○ Observe the specified tightening torques.
When tightening, use a calibrated torque
wrench.
○ When working with heavy parts use suit-
able lifting tools.
○ Avoid mixing up or wrong assembly
of dismantled parts. Mark these parts
accordingly.
1.19 Initial commissioning / daily start-up
Ensure that:
○ All safety devices are completely available
and functional
○ All connections are correctly connected
○ All parts are correctly installed
○ All warning labels on the product are
present completely, highly visible and
undamaged
○ Illegible or missing warning labels are to
be replaced without delay
To Next Page
Loading...
