- 16 -
951-171-016
Version 03
EN
1. Safety instructions
1.21 Residual risks
Residual risk
Possible in life
cycle
Prevention/ remedy
Personal injury / material damage due to
falling of raised parts
A, B, C, G, H, K
Keep unauthorized persons away. No people may remain under suspended loads. Lift parts
with suitable and tested lifting devices.
Personal injury / material damage due to
tilting or falling of the product because of
non-observance of the stated tightening
torques
B, C, G
Observe the specified tightening torques. Fix the product only to components with sufficient
load capacity. If no tightening torques are stated, apply tightening torques according to the
screw size characteristics for 8.8 screws.
Personal injury / material damage due to
electric shock because of damage to the
connection cable
B, C, D, E, F, G, H
Check the connection cable with regard to damages before the first usage and then at
regular intervals. Do not mount cable to moving parts or friction points. If this cannot be
avoided, use spring coils respectively protective conduits.
Personal injury / damage to material due
to spilled or leaked lubricant
B, C, D, F, G, H, K
Be careful when filling the reservoir and when connecting or disconnecting lubricant feed
lines. Always use suitable hydraulic screw connections and lubrication lines for the stated
pressures. Do not mount lubrication lines to moving parts or friction points. If this cannot be
avoided, use flexible hose lines or spring coils respectively protective conduits.
Life cycle: A = transport, B = installation, C = initial start-up, D = operation, E = cleaning, F = maintenance, G = fault, repair,
H = shutdown, K = disposal
To Next Page
Loading...
