EN
6. Assembly
- 34 -
951-171-016
Version 03
6. Assembly
6.1 General information
Only qualified technical personnel may install
the products described in these Instructions.
During assembly pay attention to the
following:
○ Other units must not be damaged by the
assembly.
○ The product must not be installed within
the range of moving parts.
○ The product must be installed at an ad-
equate distance from sources of heat and
coldness.
○ Observe the product's IP type of
protection.
○ Adhere to safety distances and legal pre-
scriptions on assembly and prevention of
accidents.
○ Possibly existing visual monitoring de-
vices, e.g. pressure gauges, MIN/MAX
markings, oil-level sight glasses or piston
detectors must be clearly visible.
○ Observe prescriptions in the Technical
data (chapter 4) regarding the installation
position.
6.2 Place of installation
Protect the product against humidity,
dust and vibrations and install it in an
easily accessible position to ensure all
other installations can be carried out
without any problem.
To Next Page
Loading...
