Page 11 of 77
SKIPPER Electronics AS
Edition: 2017-06-12
GDS102 Operation and Installation Manual
First Page Last PagePrev Page Next Page
Chapter: 1. Introduction
Additional Features
In addition to the features demanded by the IMO regulations, the following features are available:
Repeaters/Slaves
Graphic CRT or LCD display or digital depth slave repeaters may be connected to the system.
Auto Range
This feature will automatically adjust the depth range to maintain the bottom contour within the middle
half of the screen height, and is accessible on screen 3. See “Fig. 2.4. Screen 3. Power adjustment and
options.” on page 16.
External Printer
Printer for endless paper or inkjet printer for single sheets (ask SKIPPER for available types) may be con-
nected for hardcopy requirements.
Options
• Remote keyboard.
• Permanent reduction of output power for adaption to various transducers.
Non-standard features, available as options, which are not approved for normal use for navigation by IMO
(contact SKIPPER for more information) include:
Remote Sounding Control
This option lets the GDS102 being controlled remotely in continuous/edge/level/single (manual) ping
modes. It can be useful in case of multiple hydroacoustic installations to avoid interference between
dierent systems. If installed, this option is accessible on screen 3. See “Fig. 2.4. Screen 3. Power
adjustment and options.” on page 16.
Sound Speed Calibration
This option will enable adjustment of the sound speed value used for the depth calculations. The
standard value is 1500 m/s, but the user may set values from 1400 to 1550 m/s to accommodate accurate
propagation speed in known water conditions. If installed, this option is accessible on screen 3. See “Fig.
2.4. Screen 3. Power adjustment and options.” on page 16.
To Next Page
Loading...
Need help?
General
