Skipper GDS102 - Voltage Selection Connectors and Fuses, Terminal Board; Fig. 3.4. AC Voltage Selection and Fuses

Page 41 of 77
SKIPPER Electronics AS
Edition: 2017-06-12
GDS102 Operation and Installation Manual
First Page Last PagePrev Page Next Page
Chapter: 3. Installation
Fig. 3.4. AC Voltage selection and fuses.
Transformer primary to:
• J102 for 230 V AC.
• J103 for 115 V AC.
(Fit dummy plug on opposite connector for protection).
Fuses:
• 230 V AC: FS100 and FS101 must be 0.5 A slow blow.
• 115 V AC: FS100 and FS101 must be 1.0 A slow blow.
• 24 V DC: FS102 must be 3.15 A slow blow.
Voltage selection connectors and fuses, Terminal Board