Page 44 of 77
SKIPPER Electronics AS
Edition: 2017-06-12
GDS102 Operation and Installation Manual
First Page Last PagePrev Page Next Page
Chapter: 3. Installation
Fig. 3.7. Back-up battery jumper JP200, on I/O board.
Important: After the installation is complete and the system power is applied, it is necessary to connect
the back-up battery to provide power to the user parameters during system power failure. Refer to g. 3.7
for the correct setting of the battery jumper “ON” position 2 to 3. This jumper should be set to the “OFF”
position 1 to 2 only during extended unit storage periods. The battery is in use only when no power is
applied to the power terminals.
Back-up battery jumper JP200
1
2
3
JP200 location on I/O board
OFF ON
To Next Page
Loading...
