Skipper GDS102 - Operation Screens

Page 13 of 77
SKIPPER Electronics AS
Edition: 2017-06-12
GDS102 Operation and Installation Manual
First Page Last PagePrev Page Next Page
Chapter: 2 Operation
Operation Screens
Each of the operation screens contains a graphic picture and a selection of up to 6 soft key buttons. The
various screens are selected by keeping the SCREENS button pressed and rotating the encoder in either
direction. Turning the encoder clockwise cycle the screens in the sequence 1 to 13, and counter clockwise
rotation cycles the screens in the sequence 13 to 1. Screens 1, 2 and 3, covering the primary functions, may
also be cycled by repeatedly pressing the SCREENS button.
The screen layouts are outlined in g. 2.2 through 2.13. The various soft key functions are described with
each screen.
Note: Some of the soft keys on the following pages appear “dimmed”. The reason for this, is that the screen
shots are taken in “demo” mode.
Note: The primary and secondary channels frequencies are indicated at the top of the screens along with
draught settings regardless of the selected screen and graphic screen layout. PRIMARY channel information
is marked by blue colour. (See below).
Primary channel
indication
Draught
indication
Time indication
manual or from
GPS
Draught
indication
Position
from GPS
Speeed
indication
from GPS
Heading
indication
from GPS
Depth type
indication