Page 20 of 77
SKIPPER Electronics AS
Edition: 2017-06-12
GDS102 Operation and Installation Manual
First Page Last PagePrev Page Next Page
Chapter: 2 Operation
Fig. 2.8. Screen 7. Interface setup screen.
Soft key Name Range/value Default
value
Description
1 (Optional) ENABLE Pos/neg Positive Selection of polarity of remote sounding control signal.
Note: This function is operative, if remote sounding
control option is installed.
2 PULSE 100, 200, 400, 2000/nm 200/nm The number of pulses per nautical mile. Setup for pulse
input that can be connected to a speed log.
3 ANA UPPER 0 - 49 m 0 m Analogue output shallow limit, depth value
corresponding to 0 V (4 mA) on the analogue output.
4 ANA LOWER 1 - 5000 m 50 m Analogue output deep limit, depth value corresponding
to 10 V (20 mA) on the analogue output.
5
6 MAX RANGE 200 m
500 m
1000 m
1500 m
5000 m
500 m Selection of maximal operating range. The maximal
detectable depth is dependant on the frequency and
properties of the transducer. This setting can be used to
avoid unnecessary high range adjustments by the range
key.
To Next Page
Loading...
