■
Sound
- Sound setup
■
Volume
- Volume setting
■
Bass - Mid - Treble
- Sets the bass, mid and treble
■
Balance - Fader
- Sets the balance between left and right, front and rear
Example menu
■
xyz
- the first menu level
■
xyz
- the second menu level
■
xyz
- the third menu level
■
xyz
- the first menu level
Input screen with keypad for search
Fig. 3
Input screen for the search
The input screen with keypad is used to find entries in the unit memory (e.g.
phone contacts, addresses, etc.).
By pressing the function key with the corresponding character on the keypad of
the input screen, this character appears in the text line
A
.
Only those letters or symbols making up a logical entry will be available. Do not
forget to enter the blank space in names made up of more than one word, such
as Lorem Ipsum. It is not necessary to enter the entries including special charac-
ters (diacritics).
The search for the most relevant terms is already initiated while you are entering
characters. Therefore, it is not necessary to enter the entire entry name.
In addition to the text line
A
, the number of matching entries is shown in the
function key
B
.
The number 1-99 indicates the number of matching entries that were found. If
even more entries were found, ** is indicated instead of a number. If less than 6
entries were found, a list of the found entries opens automatically.
Description of the function keys
Button Description
Returns to the higher-level menu
Displays a menu with selected entries, indicates the number of
matching entries
Deletes previous characters in the text line
Toggles between upper case and lower case characters
Displays the character set of the additional keypad lan-
guage » page 12
123 Switches to numeric and special character input
#
Switches to special characters
ABC Switches to letters
Enters a blank
OK/
C
Confirm the text entered in the input line, or use
C
to start
searching for a stored entry
Input screen with keypad for storing
Fig. 4
Input screen for storing
For the entry procedure and the description of the function keys, see » page 8,
Input screen with keypad for search.
The input screen with keypad is used for free text entry, e.g. for entering a name.
If there is already an entry in the text line
A
, it can be edited before storing.
›
The entry is stored in the unit memory by pressing the function key
B
.
›
The function keys
<
/
>
are used to move the cursor within the text line.
8
Introductory information (familiarisation with the unit)
To Next Page
Loading...
Need help?
General
