Voice control of the unit
Introductory information
You can use voice control only in phone or navigation mode. Voice control set-
tings » page 13.
The period of time during which the system is ready to receive voice commands
and to carry them out is called a dialogue. The system gives audible feedback and
guides you if necessary through the relevant functions.
The microphone for voice control is inserted in the moulded headliner and direc-
ted to the driver and front passenger. Therefore the driver and the front passen-
ger can operate the equipment.
Voice control symbols
Symbol Description
The system plays an acoustic message.
The system is waiting for a voice command.
Voice command entry was stopped.
Briefly pressing the
VOICE
or
button on the multifunction steering wheel dur-
ing an acoustic message terminates it, and a voice command is expected. It is not
necessary to wait for the end of message playback. The input is therefore faster.
Switching on/off
Switching on voice control
›
Briefly press the button
VOICE
on the unit.
›
Briefly press the button
on the multifunction steering wheel.
Switching off voice control
›
Press the button
VOICE
on the unit for a long time, or press it twice.
›
Press the button
on the multifunction steering wheel for a long time, or
press it twice.
›
Touch the screen with your finger (any part of the screen with the exception of
the function key
).
›
Press a button on the unit (with the exception of brief pressing of the button
VOICE
).
›
By speaking the voice command Cancel voice control.
Operation
Only give voice commands when the symbol is displayed on the device screen
or in the information display.
Voice commands
After turning on voice control, a menu with basic voice commands for the given
operation is displayed on the screen. You can switch this menu on and
off » page 13.
The ability to say a voice command can also be displayed by using acoustic sig-
nals. The acoustic signals can be switched on/off » page 13.
When you give the voice command Help, the unit displays a menu containing pos-
sible voice commands. Repeating the voice command Help will cause the unit to
display the second part of the help menu, if applicable.
When you give the voice command Start tutorial, the unit plays one of the seven
parts of the voice control tutorial.
With the voice command, you can turn on the green-highlighted function keys
(operation in the manner “Say what you see”). For example, you can turn on the
function key
Dial number
with the voice command Dial number.
Ability to give a new voice command
If, for example, you give an incorrect voice command and the
symbol is still dis-
played, you can start the voice command again.
A new voice command input can be done in one of the following ways:
›
by briefly pressing the button
VOICE
on the unit;
›
by briefly pressing the button
on the multifunction steering wheel.
The unit displays the
symbol again and you can give a new voice command.
Stopping voice command input
In some menus, the procedure for entering voice commands can be stopped by
turning the knob
2
» Fig. 1 on page 6.
1)
A2DP and AVRCP are Bluetooth
®
profiles that support multimedia functions.
14
Introductory information (familiarisation with the unit)
To Next Page
Loading...
Need help?
General
