132
SJ3220, SJ3226, SJ4720, SJ4726, SJ4732223198ABA
Section 5 – Procedures Base
Integrated Hub Wheel Removal
1. Use an appropriately rated lifting device to raise
up the MEWP until all the wheels are off the
ground. Set the MEWP on stands adequately
rated to support the weight of the machine.
2. Remove and set aside the wheel motor nut or
castle nut.
3. Remove and discard the locktooth washer or
cotter pin. A new one will be required for re-
installating the hub/integrated hub wheel.
4. Use two 3/8”-24 bolts with a hub puller to remove
the wheel.
5. Use a hub puller to remove and discard the hub/
integrated hub wheel from the wheel motor or
brake.
To Next Page
Loading...
