156
SJ3220, SJ3226, SJ4720, SJ4726, SJ4732223198ABA
Section 5 – Procedures Skycoded Module
Menu Selection Sub-Menu Description
LIFT (CONT.)
UP ACCEL Determines the time for acceleration of lifting
UP ACCEL
STOWED
Determines the time for acceleration from stowed
UP DECEL Determines the time for deceleration
DOWN MIN Determines the slowest lowering speed (when the joystick is at 0% demand)
DOWN MAX Determines the fastest lowering speed (when the joystick is at 100% demand)
DOWN ACCEL
Determines the rate of increase of lift speed when higher speeds are demanded as well as lowering speed, if
lowering is controlled by the pump or a proportional valve.
DOWN DECEL
Determines the rate of decrease of lift speed when lower speeds are demanded as well as lowering speed, if
lowering is controlled by the pump or a proportional valve.
MAX HEIGHT Determines the height above which lifting is prevented.
ARMGUARD
Press ENTER to dispaly sub-menu to access adjustments related to armguard
TIME Determines the time delay when armguard triggers during lowering, before lowering is allowed to continue
@HEIGHT Determines the height at which “soft armguard” occurs when lowering
DOWN
MAXarmguard
Determines the speed at which "soft armguard" occurs when lowering
VALVE
CYLINDER
Determines the location of the Proportional Valve (Main manifold or Cylinder)
CUSHION@
CUSHION @
HEIGHT
Determines the height at which the cushion occurs
CUSHION
DOWN MAX
Determines the speed at which the cushion is enabled
STEER
SPEED Determines the pump speed when steering is used on its own (without drive).
DRIVE COMP
Determines the additional speed to apply to the current drive speed when steering is used when driving while
the platform is not elevated – it can be adjusted to minimize any slow down in drive speed due to steering
demand.
ELEV DRIVE
COMP
Determines the additional speed to apply to the current drive speed when steering is used when driving while
elevated.
ACCEL Determines the rate of increase of pump speed when steering is selected on its own (without drive)
DECEL Determines the rate of decrease of drive speed when steering is selected on its own (without drive)
DECK
OUT MIN Determines the slowest deck out (extend) speed (when the joystick is at 0% demand)
OUT MAX Determines the fastest deck out (extend) speed (when the joystick is at 100% demand)
IN MIN Determines the slowest deck in (retract) speed (when the joystick is at 0% demand)
IN MAX Determines the fastest deck in (retract) speed (when the joystick is at 100% demand)
ACCEL Determines the rate of increase of deck speed when higher speeds are demanded
DECEL Determines the rate of decrease of deck speed when lower speeds are demanded
GROUNDMODE
UP Determines the (xed) lifting speed in Base mode
DOWN Determines the (xed) lowering speed in Base mode
OUT Determines the (xed) deck out (extend) speed in Base mode
IN Determines the (xed) deck in (retract) speed in Base mode
ACCEL Determines the rate of increase of lift/lower/deck speeds in Base mode
DECEL Determines the rate of decrease of lift/lower/deck speeds in Base mode
Skycoded Control Module Menu Table (Continued)
To Next Page
Loading...
