SMA Solar Technology AG Switching On and Off
Technical Description SI5048-TB-TEN110340 63
4. Wait 5 seconds.
☑ The Sunny Island skips the QCG and the
notification shown here is displayed.
5. Press and hold <ENTER>.
☑ The remaining time is displayed as a bar.
☑ On a slave, the notification displayed here is
shown until the master is started.
6. Press <ENTER> on the master.
☑ A beep is heard. The Sunny Island is in operation and the green (top) LED is on.
9.2 Stopping the Sunny Island (Standby)
Proceed as follows to stop the Sunny Island:
1. Press <ENTER> or <ESC> to stop the Sunny Island.
☑ The notification shown here is displayed.
2. Press and hold <ENTER>.
☑ The remaining time is displayed as a bar.
☑ The Sunny Island is stopped. The notification shown
here is displayed.
Standby
Even in standby mode the Sunny Island still requires approx. 4 W of power from the
battery.
To Next Page
Loading...
