SMA Sunny Island 5048 - Changing Parameters

Operation SMA Solar Technology AG
70 SI5048-TB-TEN110340 Technical Description
600# Direct Access -Direct access to the parameters
This is a main menu that gives you direct access to the settings and display values (see section
10.3”Direct Access - Direct Access to the Parameters” (page71)).
10.2 Changing Parameters
Using the up and down arrow buttons, you navigate through a selected menu to view or change a
parameter, for example. When the relevant parameter is displayed, you can read its present value.
An arrow next to the value indicates that the parameter can be changed.
If you press <ENTER>, the arrow begins to blink, and you can use the up and down arrow buttons to
change the value of the "150# Compact Meters" parameter.
As soon as the desired value appears on the display, press <ENTER> to save the new value.
Then select Y(es) or N(o) by pressing the up/down arrow buttons to accept or reject the changes.
Finally, press <ENTER> again in order to finish the process and continue with other modifications.
Increments (speed)
The increment size (speed) of the change increases if you hold the button pressed down.
Changing parameters
Note that some parameters can only be changed when the device is in standby mode (see
section 9.2”Stopping the Sunny Island (Standby)” (page63)). The parameters for which
this applies can be found in the tables in sections 19.2”Adjustable Parameters”
(page158) and 20”Troubleshooting” (page194).