Archiving Data on a SD Card SMA Solar Technology AG
86 SI5048-TB-TEN110340 Technical Description
11.1 Inserting the Card
Insert the SD card with the cut corner pointing down into
the slot on the Sunny Island (see illustration).
After inserting the SD card into the Sunny Island, the
adjacent message appears on the display prohibiting the
removal of the card:
The initialization of the SD card can take several minutes. During this time, the buttons are disabled
and cannot be used for making entries, and three points appear in the lower line of the display.
If the procedure was successful, the graphic shown here
is displayed.
In case of a fault, the following message appears:
NOTICE!
Damage due to electrostatic discharges.
• Ground yourself before you insert or remove the SD card from the Sunny Island
enclosure.
To Next Page
Loading...
