CHAPTER 4
MAINTAINING THE INTERACTIVE WHITEBOARD SYSTEM
31 smarttech.com/kb/170910
l When replacing the projector lamp module:
o
Put the projector into Standby mode and wait 30 minutes for the lamp to cool
completely.
o
Do not loosen or remove any screws other than those specified in the lamp
replacement instructions.
o
Wear protective eyewear while changing the lamp module. Failure to do so can cause
injuries including loss of eyesight if the lamp shatters or bursts.
o
Use only replacement lamp modules approved by SMARTTechnologies. Contact your
authorized SMART reseller for replacement parts.
o
Never replace the lamp module with a previously used lamp module.
o
Always handle the fragile lamp assembly with care to prevent premature lamp failure or
exposure to mercury. Use gloves when touching the lamp module. Do not touch the
lamp with your fingers.
o
Recycle or dispose of the lamp module as hazardous waste in accordance with local
regulations.
You need a Phillips No. 2 screwdriver to complete these procedures.
To remove the old lamp module
1.
Switch off the power to the projector by pressing the Power button on the remote control.
2. Allow the projector to cool for at least 30 minutes.
3. Disconnect the power cable from the projector.
To Next Page
Loading...
