Copyright © 2018 SmartDrive Systems, Inc. All rights reserved. This information is intended for the use of SmartDrive 13
customers only. Any other use without the express written consent of SmartDrive Systems, Inc. is strictly prohibited.
Once diagnostic tests have completed, the Fault Code will display on the Keypad.
If no fault is found, the Sensor Bar LED1 (Target ) and LED 2 (Gear ) will remain solid for 10
seconds and the SR4 will automatically reboot. While the system is rebooting the Sensor Bar lights
will blink continuously. Once reboot has completed Sensor Bar LED1 (Target ) will display Sold
Green indicating the system is ready to record.
Keypad – The Keypad will display the sum of all identified Fault Codes. Example – if the Sensor Bar is
not found (020000) and the Ignition is OFF (010000); the Keypad will display 030000.
To Next Page
Loading...
