Keypad Operation
Some companies use the KEYPAD to identify the drivers in events. The keypad allows drivers to
enter their driver ID code. It is very important that drivers enter their keypad entry code every time
they begin their shift or switch vehicles during their shift. The keypad entry code provides accurate
identification of each driver, ensuring that they receive accurate guidance and/or accolades due to
them.
Create a manual event using the Keypad
1. Press the manual event button on the keypad.
2. If connected correctly, the keypad display will read Panic. If this does not occur,
check the keypad cable for damage and ensure the keypad is plugged into the Keypad
Port of the controller.
3. The Target LED on the Sensor Bar will blink Blue indicating a manual event has been triggered.
4. The Target LED on the Sensor Bar will illuminate solid Blue once the event is finished recording.
This indicates an event is saved and awaiting offload.
Frequently Asked Questions
Q. I entered my keypad code, but “>>>” displayed. What should I do?
A. This happens when there is a communication problem with the SR4 system. Enter your keypad
code and press the “
” button. Repeat if necessary until the keypad code is displayed.
Q. What if I make an error while entering my keypad code?
A. Press the “X” button which will erase the last number entered. Continue to press the “X” button
until all incorrect numbers are erased.
Q. The wrong number was displayed when I started my vehicle. How can I change the number?
A. Enter the correct keypad code and press the “
” button.
Note: If the System is not completely done with the boot up process, you will see arrows scroll
across the screen when the panic button is pressed. Please allow the system to completely boot.
1) Wait at least 1 full minute after power up before entering the keypad number
2) Enter no more than 5 number digits in the supported range of from 1-99990
3) Press the green check to submit the driver ID and watch for the number to flash as confirmation
To Next Page
Loading...
Need help?
General
