Smartgen HGMS61 User Manual

HGMS61 Genset Controller User Manual Page 16 of 47
No.
Shutdown
Description
15
Low Coolant Level
When genset low coolant level input is active, controller will send a stop
alarm signal and it will be displayed on LCD.
16
Temp. Sensor Open
When sensor cannot be connected to corresponding port, controller will
send shutdown alarm signal and it will be displayed on LCD.
17
Oil Sensor Open
When sensor cannot be connected to corresponding port, controller will
send shutdown alarm signal and it will be displayed on LCD.
18
Maintenance Due
shutdown
When genset running is longer than maintenance time of user setting,
and maintenance action is set as shutdown, when genset starts,
controller will send shutdown alarm signal and it will be displayed on
LCD. Maintenance alarm can be reset by setting the maintenance
parameters with the password.
19
Input Port Shutdown
When external input is active, controller will send shutdown alarm signal
and it will be displayed on LCD.
20
Over Power Shutdown
When the controller detects that the over power value (power is positive)
has exceeded the pre-set value and the action select “Shutdown”, it will
send a shutdown alarm.
21
ECU Shutdown
If the controller receives the shutdown alarm signal via J1939, it will
send a shutdown alarm.
22
ECU Comm. Failure
If the controller does not receive the data via J1939 after starting the
engine, it will send a shutdown alarm.

Smartgen HGMS61 Specifications

General

Brand	Smartgen
Model	HGMS61
Category	Controller
Language	English