Tethys D60 - Tethys T60 - Tethys T45
9 CLEANING AND MAINTENANCE
9.1 PRELIMINARY PRECAUTIONS
DISCONNECTING THE ELECTRICITY AND WATER SUPPLIES
Before doing any work: disconnect the power supply using the appropriate switch on the panel or
disconnecting the power cable, and turn off the water intake tap.
WORKING SPACE REQUIRED
A space of approx 1m
2
is required in front of the appliance for cleaning and maintenance to be
carried out without difficulty.
AUTHORISED TECHNICAL STAFF.
Any work done on the appliance by unauthorised staff is not covered by the warranty and is
performed under the user’s responsibility.
During maintenance and cleaning: if appropriate, use personal protection equipment.
9.2 CLEANING THE DEVICE AND ITS PARTS
General cleaning
The external surfaces and inner door of the device must be cleaned at regular intervals (once a month is
recommended) with a soft cloth soaked in water or a normal detergent for steel surfaces.
The door seals must be cleaned with a damp sponge.
After cleaning, a washing cycle should be carried out without a load for processing, to remove any detergent residues.
fig. 36 – The inside and outside of the device must be cleaned.
To Next Page
Loading...
