Typical Disablement Messages
The following table shows some typical disablement messages and indications that may appear at the panel.
Message Indication Meaning Action
Zone Disabled
at card n
The zone specified has
been manually or
automatically disabled.
If manually disabled then
investigate and if
necessary re-enable the
zone.
Device disabled
at card n
The device connected to
the loop circuit has been
manually or
automatically disabled.
Additional indication is
given if it is a sounder
device.
If manually disabled then
investigate and if
appropriate re-enable the
device.
Sector disabled
at card n
The fire alarm sector on
loop n has been
manually or
automatically disabled.
If manually disabled then
investigate and if
appropriate, re-enable the
sector.
Disabled Aux
Relay n
The auxiliary relay n in
the control panel has
been manually or
automatically disabled
If manually disabled then
investigate and if
appropriate, re-enable the
aux relay.
Master alarm(s)
disabled
The master alarms have
been manually or
automatically disabled.
If manually disabled then
investigate and if
appropriate, re-enable the
master alarms.
&
Any changes to the setting of an automatic disablement must only be
attempted by a trained engineer who is responsible for the fire alarm system, see
contact details in the Log book.
17
fire system
Sounder
On
Flashing
Disablement
Disablement
Disablement
Sounder
Disablement
Disablement
Sounder
To Next Page
Loading...
