Battery replacement
It is recommended where batteries are installed they must be replaced at 4 Yearly intervals from the date the
system is first commissioned.
"
Any servicing work on the system must be carried out by a suitably trained
person, such as an engineer from the servicing organisation.
Repair function
"
Any wiring fault on the system must be rectified by an engineer from the
servicing organisation, for contact details see the log book. A wiring fault will require
correction to the wiring before running a [Repair] command at the main panel.
The repair function is accessible using customer (level 2) password, under normal circumstances it is
unnecessary to use this function.
a. Press the MENU ON/OFF key.
b. Press the F1 button to select [Test/Engl].
c. Press the F4 button to select [UserCode]. Notice a flashing cursor and a message on the display 'Enter
access code'. Use the keyboard to input your password and then press the Enter button.
d. Press the F1 button to select [Loop] and F1 button to select [Repair] notice 'Loop' followed by a flashing
cursor on the display. Use the keypad to input a loop number 1 or 2 and then the F2 button to select
[Enter].
Gent by Honeywell reserves the right to revise this publication from time to time and make changes to the content hereof without
obligation to notify any person of such revisions of changes.
Hamilton Industrial Park, Waterside Road, Leicester LE5 1TN
Telephone: +44 (0)116 246 2000 Fax (UK): +44 (0)116 246 2300
32 4188-901 issue 2_11-09_SenTRI-Ops
Operating instructions
Do not dispose of with your normal household waste.
Do not burn.
WEEE Directive:
At the end of their useful life, the packaging,
product and batteries should be
disposed of via a suitable recycling centre.
At the end of their useful life, the packaging,
product and batteries should be disposed of
via a suitable recycling centre and in
accordance with national or local legislation.
0832
Gent by Honeywell
Hamilton Industrial Park, 140 Waterside Road, Leicester LE5 1TN, UK
0832-CPD-1286 2-LOOPS (SENTRI)
Control and Indicating equipment for fire detection and fire alarm systems
in buildings.
SenTRI
EN54-2: 1997, A1:2006
7.8 Output to fire alarm devices
7.11 Delays to action outputs
8.3 Fault signals from point
9.5 Disablement of each addressable point
10 Test condition
Power supply equipment for fire detection and fire alarm systems in
buildings.
Other technical data: see documents in project file 7032, held by the
manufacturer.
EN54-4: 1997, A1:2002, A2:2006
To Previous Page
Loading...