154
https://snapmaker.com/
6.3.4 Clean the Finished Work and the Machine
1. Remove the clamp set from the CNC carving and cutting platform.
2. Clean the finished work and the machine with a dust collector.
After each CNC job, you need to clean the dust screen of the CNC Module and the machine
surface with a dust collector or cotton swabs. Failure to clean the CNC Module after 150
hours of operation may result in motor dysfunction due to dust accumulation.
Do NOT rinse the CNC Module with water, and it is also not recommended to wipe the module
with alcohol.
To Next Page
Loading...
