User Guide 39
For regulatory identication purposes, your product number is:
FCC ID: J9CFTD1 for the Tagg™ tracking device.
FCC ID: J9CFBC1 for the docking station.
• This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving docking station.
• Increase the separation between the equipment and the docking station.
• Plug the docking station into another electrical outlet away from the receiver that is
experiencing interference.
• Contact Customer Care at www.tagg.com for help.
• This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
• To comply with FCC RF exposure compliance requirements, a separation distance of 20 cm (8
inches) must be maintained between the antennas for the Tagg tracking device and all persons.
• For more information regarding this requirement, please visit our Answer Center located on the
Support page of our website.
• Changes or modications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the Tagg tracking device.
• In an aircraft:
• The Tagg tracking device transmissions could interfere with aircraft electrical and
communications systems. Turn off the Tagg tracking device before entering the aircraft
(see page 7 for instructions).
• Potentially Explosive Environments:
• Turn off the Tagg tracking device when in any area with a potentially explosive atmosphere
and obey all signs and instructions. Sparks in such areas could cause an explosion or re
resulting in bodily injury or even death.
• Turn off the Tagg tracking device while at a fuel distribution or storage area, chemical
plant, where blasting operations are in progress and areas where the air contains
chemicals or particles such as grain dust metal powders and any other area where you
would normally be advised to turn off your vehicle engine.
REGULATORY STATEMENTS REGULATORY STATEMENTS
To Next Page
Loading...