Snom 710 - Rotating the Tab of the Cradle

13
snom 710 User Manual Setting up the Phone
Fig./Abb. 1 Fig./Abb. 2 Fig./Abb. 3
3. Plug the short end of the handset cord into the connector on the handset.
4. Place the phone on an even, horizontal surface.
Rotating the tab of the cradle
The phone is delivered with the tab level with the inner edge of the cradle. If you are going to mount
the phone on a wall, we recommend that you rotate the tab 180°. After rotation, the tip of the tab will
protrude slightly above the edge of the "cradle". The small rectangular hole in the receiver casing fits
perfectly over the now protruding tip, holding the receiver safely in place in the upright position on the
wall.
Fig./Abb. 1 Fig./Abb. 2 Fig./Abb. 3
1. Slide the plastic tab from the cradle (Fig. 1)
2. Rotate the tab 180°.
3. Slide the tab back into the cradle (Fig. 2). The top of the tab now protrudes slightly above the
inner edge of the cradle (Fig. 3), so that it will hold the handset more securely.
The wall mounting instructions are attached at "Appendix 3 - Wall Mounting" on page 85.