Snom 710 - Configuring Call Forwarding Settings

54
snom 710 User Manual Using the Phone
Changing the settings on the phone and turning on call forwarding
Forward all Forward when busy Forward after timeout
Press
Settin
Settin Settin
Press
2
ABC
2 Call Features
2
ABC
2 Call Features
2
ABC
2 Call Features
Press
1
1 Call Forwarding
1
1 Call Forwarding
1
1 Call Forwarding
Press
1
1 Forward All
2
ABC
2 When Busy
3
DEF
3 On Timeout
Press
2
ABC
2 Target
2
ABC
2 Target
2
ABC
2 Target
Type phone number phone number phone number
Press
Press - -
3
DEF
3 Time
Type - - number of seconds
Press - -
Press
1
1 Activate
1
1 Activate
1
1 Activate
The setting will change to "1
Activate", indicating that call forwarding is now active. Press for
two seconds to return to the idle screen.
The status line and the status info screen will indicate that call forwarding is turned on and what
number calls will be forwarded to.
Note: Forwarding when busy and after timeout are indicated in the status bar, which can
display only one message at a time. When both are active at the same time, only "Forward
when busy" will be displayed. If there are other status messages with a higher priority
than "Forward when Busy" (e.g., firmware update available, reboot required, waiting for
call completion, etc.), they will take precedence over the call forwarding indication.
Press
Info
to show status information with all current status messages, including call
forwarding.
Forwarding when busy or after timeout:
Forwarding all calls:
Turning on forwarding of all calls with a programmed function key
If the function key
CFwd
is not available when the display is in idle mode, you can make it available
on the Function Keys page of the phone's web interface. For further information see "Example 4,
Turning forwarding of all calls on and off" on page 61.
1. Press
CFwd
. The display will show the "Target when Forwarding" screen.
2. If no forwarding number has been set or if it needs to be changed, make the necessary entries.