49
snom 710 User Manual Using the Phone
Putting the conference on hold
Put all participants on hold. Technically, you are, in effect, terminating the conference. You will see the
"Calls on Hold" screen (see "Holding multiple calls" on page 47).
Press
Cnf.On
to restart the conference, i.e., start another conference with all calls on hold.
Adding a participant
• Adding an incoming call:
1. Press or the blinking line key to accept the call. The conference is put on hold.
2. Press
Cnf.On
to start a conference with all held calls, including the additional participant.
• Calling a new participant:
1. Press
Hold
to put the conference on hold.
2. Dial the number of the new participant.
3. With the new participant on the line, press
Cnf.On
.
Terminating the conference
1. Press
Hold
to put all participants on hold.
2. Select each participant in turn and press .
Putting one participant on hold
1. Press the participant's line key. You need to remember which lines the individual participants are
on!
2. Press
Cnf.On
to return held participant to conference.
Speaking to one participant in private
1. Press
XFER
to put all conference participants on hold and continue as shown in "Holding
multiple calls", above.
Alternatively, press the participant's line key twice to connect to that call and put the other
participants on hold. This method has the disadvantage that you need to remember which lines
the individual participants are on.
2. To restart the conference, press
Cnf.On
.
Dropping a participant
1. Press the participant's line key. You need to remember which lines the individual participants are
on!
2. Press to terminate the connection to this participant.
To Next Page
Loading...
