EasyManua.ls Logo

SolarEdge SE1000

SolarEdge SE1000
49 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 5: LCD – Status Screens and Setup Options
Control and Communication Gateway Installation Guide - MAN-01-00132-1.2
35
Setup Menu Options
This section describes basic gateway configuration options.
1 Verify that the SolarEdge gateway is connected to a power outlet.
2 Press the Enter button until the following message is displayed:
P l e a s e ente r
P a s s w o r d
* * * * * * * *
The gateway is now in Setup mode and all its LEDs are lit. The gateway automatically exits Setup
mode if no buttons are pressed for more than 2 minutes.
3 Use the three-right-most LCD buttons to type in the following password: 12312312. The following
message is displayed:
L a n g u a g e < e n g >
C o m m u n i c a t i o n
S e n s o r s
D i s p l a y
M a i n t e n a n c e
I n f o r m a t i o n

Table of Contents

Related product manuals