Solartron 1287 - Page 62

ui itapit?!
1 Vj
10
DATA OUTPUT
This section
of the menu allows
the user to enable or disable
any of the possible
devices,
configure
the GPIB for remote control
and set
up the
filing
of
measurements.
The various output formats
are described in Chapter 4.
10.1 {RS-423}
>
>
Remote command
is RS/. Refer to Chapter
4,
Section 6.19.
The RS-423
serial interface port. Two
selections are
possible, other than
[off]:
[on]
and [dump] (see
chapter
4
for descriptions
of these output formats).
10.2 {GPIB}
> >
Remote
command is GP7. Refer
to
Chapter
4,
Section 6.
1 9.
General Purpose
Interface Bus. Four selections
are possible,
other than [off]:
[long on], [short
on], [long dump], and
[short dump]
(see chapter 4 for
descriptions
of these output formats).
After selecting
one of
these four options, further selections
are made available
;
•
Serial Poll > >
Remote
command is
SV7.
Enter an integer to
configure the SI1287
to interrupt
the GPIB controller
when a particular
event
(defined by the integer) occurs.
•
Parallel Poll
>
>
Remote
command is PP7.
Enter
an integer to
define
which
of the eight
GPIB
data
lines is
to be used
by the SI1287 to give
a parallel poll
response, indicating
whether it is
requesting
service or not.
•
PP Sense >>
Remote
command is SE/.
Parallel
Poll Sense.
[true]
signifies
that
when the data line carries
a
"1"
the
SI
1287 is requesting
service.
[false]
signifies
that when the line carries
a
"0"
the SI1287 is
requesting service.
•
O/P Terminator > >
Remote command
is OT7.
Output Terminator.
The character terminating
each line
of data.
cr
=
carnage return
If = line feed
EOI
=
end
or identify.
•
O/P Separator > >
Remote command
is OS7.
Output
Separator. The character separating
the line of
data into fields.
If
[term.] is selected, the
separator character
is set to be the same
as the
terminator character.
3.28 JWS
/ S1 1 287 User Guide
/
issue
AF