15
5. Declaration of Conformity
Declaration of Conformity
for installation of an incomplete machine in accordance
with the Machinery Directive 2006/42/EC, Annex II, Part 1 A
SOMMER Antriebs- und Funktechnik GmbH
Hans-Böckler-Straße 21–27
D-73230 Kirchheim/Teck
Germany
hereby declares that the roller door control unit
RDC Vision
+
have been developed, designed and manufactured in conformity with the
• Machinery Directive 2006/42/EC
• Low Voltage Directive 2014/35/EU
• Electromagnetic Compatibility Directive 2014/30/EU
• RoHS Directive 2011/65/EU
The following standards were applied:
• EN ISO 13849-1, PL “D” Cat. 2
Safety of machines – safety-related parts of controls
– Part 1: General design guidelines
• EN 60335-1, where applicable
Safety of electrical appliances / operators for gates
• EN 61000-6-3
Electromagnetic compatibility (EMC) – interference
• EN 61000-6-2
Electromagnetic compatibility (EMC) – interference resistance
The following requirements of Annex 1 of the Machinery Directive 2006/42/EC are met:
1.1.2, 1.1.3, 1.1.5, 1.2.1, 1.2.2, 1.2.3, 1.2.4, 1.2.6, 1.3.2, 1.3.4, 1.3.7, 1.5.1, 1.5.4, 1.5.6, 1.5.14, 1.6.1, 1.6.2, 1.6.3,
1.7.1, 1.7.3, 1.7.4
The special technical documents have been prepared in accordance with Annex VII Part B and will be submitted
electronically to the regulators on request.
The incomplete machine is intended for installation in a gate system only to form a complete machine as defined by
the Machinery Directive 2006/42/EC. The door system may only be put into operation after it has been established
that the complete system complies with the EC Directives listed above.
The undersigned is responsible for compilation of the technical documents.
Kirchheim, 7 August 2018
i.V.
Jochen Lude
Responsible for documents
To Next Page
Loading...
Need help?
General
