SOMMER RDC Vision+ User Manual

6
1. About this Installation and Operating Manual
1.8 Intended use
The roller door control unit RDC Vision
+
may only be used:
• to control motors in roller doors (max.: 1,000 W).
• if the system is in perfect technical condition.
• in accordance with the safety instructions and
warnings provided in this Installation and Operating
Manual.
1.9 Improper use
The roller door control unit RDC Vision
+
may not be used
in conjunction with motors in roller grille doors.
Any use above and beyond that described in Chapter
“Intended use” on page 6 constitutes improper use.
The user bears the sole responsibility for any risk involved.
The manufacturer's warranty will be voided by:
• damage caused by other use and improper use
• use with defective parts
• unauthorisedmodicationstotheproduct
• modicationsandnon-approvedprogramming
of the product and its components
The product must not be used in:
• areas with explosion hazard
• very salty air
• aggressive atmosphere, including chlorine
1.10 Qualifications of personnel
Qualied specialist for installation,
commissioning and disassembly
This Installation and Operating Manual must be read,
understood and complied with by a qualified specialist
who installs or performs maintenance on the control unit.
Work on the electrical system and live parts may be
performed only by a trained electrician in accordance
with EN 50110-1.
The installation, initial operation and disassembly of the
control unit may only be performed by a qualified specialist.
The qualified specialist must be familiar with the following
standards:
• EN 13241-1 Doors and gates – Product standard
• EN 12604 Doors and gates – Mechanical aspects –
Requirements
• EN 12605 Doors and gates – Mechanical aspects –
Test methods
• EN 12445 and EN 12453 – Safety in use of power-
operated doors
A qualified specialist is a person commissioned by the
installer. The qualified specialist must instruct the user:
• on the operation of the control unit and its dangers
• on the handling of the manual emergency release
(if installed)
• on regular maintenance, testing and care which the
user can carry out
The user must be informed that other users must be
instructed on the operation of the control unit and its
dangers.
The user must be informed about which work may only
be performed by a qualified specialist:
• Installation of accessories
• Settings
• Regular maintenance, testing and care
• Troubleshooting and repairs
• The following documents for the door system must
be handed over to the user:
• EC Declaration of Conformity
• handover protocol and inspection book
• the installation and operating manuals for the operator
and the door

SOMMER RDC Vision+ Specifications

General

Brand	SOMMER
Model	RDC Vision+
Category	Control Unit
Language	English