SOMMER RDC Vision+ User Manual

27
8. Initial operation
1. Press the Radio button repeatedly to select the
required radio channel.
2. Press the desired button on the transmitter until
the LED for the radio channel goes out.
⇒ LED goes out – programming has been
completed
⇒ The transmitter has transferred the radio code
to the radio receiver
3. Repeat the above steps to program additional
transmitters.
INFORMATION
Further transmitters cannot be pro-
grammed if all memory positions of
the handheld transmitter are occupied.
If the memory capacity has been reached:
A total of 40 handheld transmitter commands are available
for all channels. If an attempt is made to program
additional transmitters, the red LEDs of radio channels
CH 1–CH 4 blink. If more memory positions are needed,
see Chapter “10.6 Information on Memo”.
8.10 Information on Memo
The memory capacity can be extended to 450 handheld
transmitter commands using the optional Memo accessory
part. When plugging in the Memo, all available transmitters
are transferred from the internal memory to the Memo and
stored there. The Memo must remain plugged in on the
control unit.
No more transmitters are then stored in the internal
memory. Stored transmitters cannot be transferred from
the Memo back to the internal memory.
All radio channels, including the memory of the Memo,
can be deleted; see Chapter “Deleting all radio channels
in the receiver” on page 28.
INFORMATION
Delete the Memo on a new operator.
Otherwise, all stored transmitters of an
operator are deleted and must be
reprogrammed.
8.11 Cancelling programming mode
• Press the Radio button until all LEDs are off or make
no input for 30 seconds.
⇒ Programming mode is cancelled.
8.12 Deleting a transmitter button
from the radio channel
1. Press the Radio button repeatedly to select the
required radio channel.
Press and hold the Radio button for 15 seconds.
⇒ TheLEDashesafter15seconds.
2. Release the Radio button.
⇒ The radio receiver is now in deletion mode.
3. Press the transmitter button for which the command
is to be deleted in the radio channel.
⇒ LED goes out.
⇒ The deletion procedure is ended.
Repeat the process for additional buttons as required.
8.13 Deleting transmitter completely
from the receiver
1. Press and hold the Radio button for 20 seconds.
⇒ TheLEDashesafter15seconds.
⇒ Afteranother5seconds,theashsequencechanges
to blinking.
2. Release the Radio button.
⇒ The radio receiver is now in deletion mode
3. Press any button on the transmitter that is to be
deleted.
⇒ The radio receiver is now in deletion mode.
⇒ LED goes out.
⇒ The deletion procedure has been completed.
⇒ The transmitter is deleted from the radio receiver.
Repeat the process for additional transmitters as required.
8.14 Deleting a radio channel
in the receiver
1. Press the Radio button repeatedly to select the
required radio channel.
Press and hold the Radio button for 25 seconds.
⇒ TheLEDashesafter15seconds.
⇒ Afteranother5seconds,theashsequencechanges
to blinking.
⇒ After another 5 seconds, the LED of the selected
radio channel remains steady.
2. Release the Radio button.
⇒ The deletion procedure is ended.
⇒ All programmed transmitters on the selected radio
channel are deleted from the radio receiver.

SOMMER RDC Vision+ Specifications

General

Brand	SOMMER
Model	RDC Vision+
Category	Control Unit
Language	English