29
8. Initial operation
Resetting the safety devices
• Press the green Reset button for 1 second.
⇒ Reset of the connected safety devices.
⇒ Subsequently attached safety devices are detected.
Resetting the programmed run times
1. Pull the ribbon cable of the integrated 3-function pad
off the control unit circuit board.
2. Press the Reset button for 10 seconds until the green
status LED blinks quickly.
⇒ Run times deleted.
• Press the Reset button for 10 seconds until the green
status LED blinks quickly.
⇒ Force and position values deleted.
⇒ Frame photocell deleted.
Restoring the factory settings
1. Pull the ribbon cable of the integrated 3-function pad
off the control unit circuit board.
2. Press the Reset button for 15 seconds until the green
LED goes out.
⇒ Reset is performed.
To Next Page
Loading...