Sonance Navigator K2 - How to Delete Commands from Buttons; How to Link Pages

Navigator K2 keypad
22
HOW TO DELETE COMMANDS FROM BUTTONS
1. Select the Delete tool from the Tool Palette.
2. Place the mouse cursor over the button with the command you wish to
delete.
3. Click the left mouse button.
4. Select Delete IR Code from the menu.
HOW TO LINK PAGES
The Navigator K2 Manager software gives you the ability to link pages. When a
button with a page link is pushed on the Navigator K2, the linked page becomes
active, in essence turning the page.
Page links are indicated by a small green box containing the number of the linked-to
page in the lower left corner of the button.
1. Select the Assign Pages tool from the Tool Palette.
2. Place the mouse cursor over the button to which you wish to assign a
page.
3. Click the left mouse button.
4. Select the page name you wish to link to from the pop-up menu.
5. Notice the number in the green square in the lower left corner of the
button corresponds to the linked page in the list.