Navigator K2 keypad
26
HOW TO SEND A FILE TO THE NAVIGATOR K2
1. Connect the Programming Cable from the Navigator K2 serial port to the
desired COM port on your computer. This should be the COM port you set
up using the Communications Setup dialog.
2. Click the Communications Command on the Toolbar.
3. Choose Send File.
All buttons, commands, bitmaps, and macros are sent. Any existing program in the
Navigator K2 is replaced with the file you send.
All communications take place on the COM port selected with the Set COM Port
command from the Options menu.
CONTRAST
ADJ
K2 Programming Port
To Next Page
Loading...
