Navigator K2 keypad
40
HOW TO DELETE A MACRO
To delete a macro from a button:
1. Select the Delete tool from the Tool Palette.
2. Place the mouse cursor over the button with the macro you wish to
delete.
3. Click the left mouse button.
4. Select Delete Macro from the menu.
HOW TO EDIT AN IR COMMAND IN A MACRO
1. To edit an individual command in a macro you must have the macro
displayed in the Macro Editor.
2. Double click on the command in the macro you want to edit to open the
Edit Infrared Command dialog box.
The Edit Infrared Command options are:
Minimum Repeats - Enter in this box the number of times that the repeating
part of the IR code is sent by the remote. Some infrared receivers need a
command to be repeated a certain number of times to work properly, and
some may not work properly if the command is repeated at all. Even if a
command works properly, increasing the number of repeat times may be
necessary if the command is to be used in a macro. Since macro commands
are not automatically sustained while a button is pressed, they may need to
automatically repeat more times to be recognized.
Frequency – Shown in this box is the carrier frequency of the IR code, this is
set automatically. You should not need to change this value unless directed
to do so by Technical Support.
Repeat while button is pressed - Check this box to cause this IR code to be
repeated for as long as the button is held down.
Note: Only one command in any macro can have this property set.
To Next Page
Loading...
