Navigator K2 keypad
60
Navigator K2 Manager does not need to be installed for the self-contained executable
to work.
To make a Self-Downloading .EXE of the current file:
1. Choose Create Self-Downloading .EXE from the Communications
menu.
2. Choose the location you want to save the file in the Save in address box.
3. Enter the name of the file in the File Name box.
4. Click the Save button to save and close.
You can now put the .EXE file on a diskette or E-Mail it.
HOW TO USE THE “SEND” COMMAND
This command sends the current file through electronic mail. This command is only
available if your computer has a properly configured e-mail client that is
compatible with the Microsoft ® MAPI specification. Microsoft Exchange and
Microsoft Outlook are two examples of MAPI-compliant e-mail clients.
To send the current file via E-Mail:
1. Choose Send from the File menu.
2. The default E-Mail program will open with the current file inserted as an
attachment with the extension .sna.
3. Send the E-Mail as required by your E-Mail program.
HOW TO UPDATE THE FIRMWARE
This command sends a firmware file to the keypad using the programming port.
This will replace the keypad’s internal operating system and application code.
To update the firmware:
1. Connect the Programming Cable from the Navigator K2 serial port to the
desired COM port on your computer. This should be the COM port you set
up using the Communications Setup dialog.
2. Choose Update Firmware from the Communications menu.
3. Click OK.
To Next Page
Loading...
