Navigator K2 keypad
32
HOW TO MOVE A BUTTON
1. Use the Select Button tool from the Tool Palette, to select the
button(s).
2. Hold down the left mouse button to drag the selection to a new location.
3. Release the left mouse button to place the button(s).
HOW TO RESIZE A BUTTON
Existing buttons on the touchscreen grid may be re-sized using Navigator K2
Manager. The text on a button may be clipped if the size is reduced, but any
associated command or macro will not be lost.
1. Use the Select Button tool from the Tool Palette to select the button.
Note that to resize a button, only one button can be selected. If the
selection can be resized, small boxes will appear in the red border on all
four sides.
2. Position the mouse over the edge of the button that you would like to
resize.
3. Click the left mouse button.
4. Drag the mouse to change the size.
5. Release the mouse button when you have the desired size.
HOW TO PLACE A CUSTOM BUTTON
The Custom Button Library Browser allows you to select and place Custom Buttons
onto the touchscreen grid.
1. Select the Place Custom Button tool from the Tool Palette.
2. Select the library in which the custom button you want is located by
clicking the Open Library button, selecting the library and clicking
Open.
Default directory is: [C:\Program Files\Navigator K2 Manager\Custom
Buttons]
3. Click on a button name and a preview of the button will appear in the
Custom Button Library Browser.
4. Click OK to insert the custom button on the touchscreen grid and close
the Custom Button Library Browser.
To Next Page
Loading...
