Sonance Navigator K2 - Chapter 3. Navigator K2 Manager Software; Installing Navigator K2 Manager; Programming Overview

Chapter 3 • Navigator K2 Manager Software
11
Chapter 3. Navigator K2 Manager

Software
Navigator K2 Manager allows you to create the entire graphical interface for a
Sonance Navigator K2 keypad on your computer. Once the interface has been
created, it is downloaded to the Navigator K2 using the included programming cable.
Existing programming can also be extracted, modified, and re-sent to any Navigator
K2 keypad.
Software updates are available for download at no cost at www.sonance.com.
INSTALLING NAVIGATOR K2 MANAGER
For installation from the internet:
1. Using your Web browser, go to the following URL: www.sonance.com
2. When the Web page opens, locate the K2 page under Electronics. Follow
the directions to download the Navigator K2 Manager.
3. Follow the on-screen instructions.
For installation from a CD-ROM:
1. Close any open programs.
2. Place the Navigator K2 Manager compact disc into the CD- ROM drive.
3. If the installation doesn’t appear automatically, click Start and choose
Run, type d:\setup\setup.exe (For d, type the letter for your CD-ROM
drive). Click OK.
4. Follow the on-screen instructions.
PROGRAMMING OVERVIEW
Here is an overview of the process of programming a Navigator K2 from scratch.
Instructions on carrying out these tasks can be found in chapters 4 and 5.
1. Create a new page and add buttons for each source component in a
system.
2. Use the Assign Page tool to link source buttons to their respective source
component pages.
3. Assign infrared codes and other commands to buttons using the Infrared
Library.
4. Create macros using the Macro Editor (if needed).