Chapter 5 • Navigator K2 Manager Advanced Features
31
HOW TO SELECT BUTTONS
The Select Button tool is used to select buttons for cutting, copying, moving,
resizing, or property editing. When buttons are selected, they are painted in red.
To select a single button or a group of buttons next to each other:
1. Click the Select Button tool on the Tool Palette.
2. Place the mouse over one corner of the button(s) and click the left mouse
button.
3. Draw a rectangle around the buttons you wish to select in the design
window (either in the touchscreen grid or the keypad buttons).
To select multiple buttons at one time that are not next to each other:
1. Click the Select Button tool on the Tool Palette.
2. Hold down the Ctrl key on your keyboard.
3. Click the buttons you wish to select (either in the touchscreen grid or the
keypad buttons).
Note: Many Navigator K2 Manager commands can be used on selections as well as
individual buttons. Click the right mouse button on a selection for a list of available
commands.
HOW TO CUT OR COPY BUTTONS
1. Use the Select Button tool from the Tool Palette to select the
button(s).
2. Choose either the Cut Command or the Copy Command from
the toolbar.
3. The button(s) are now on the clipboard.
HOW TO PASTE BUTTONS
1. Select the page you want to paste the button(s) on from the page list.
2. Choose the Paste Command from the Toolbar.
3. Drag the button(s) to the proper place on the page.
To Next Page
Loading...
