Chapter 5 • Navigator K2 Manager Advanced Features
39
LED Control - This step allows you to manually change the
color of the LED behind the keypad’s OFF hard button. This step will be ignored if
you do not enable software control of the power LED in the Device Properties setup.
Beep - This step causes the keypad’s internal beeper to sound
off.
Relay Control - This step allows you to set the state of the
relay control output pin. This can be used to control the Sonance mute speaker
relay (Sonance part number 91550). The output pin can be set to On (closed), Off
(open), or Toggle (the opposite of its current state).
Toggle IR Code - The Toggle IR Code step causes the macro
to alternate between two different IR codes every other time the button is pressed.
In the example above, each time the button that the macro is attached to is pressed,
the commands alternate. The initial button press executes the A command and the
second button press executes the B command.
If you have equipment that uses toggle codes, you must learn each code twice, and
then place the two codes within the Toggle IR Code step. Every time the macro is
run, it will send out only one of the two codes inside of the Toggle IR Code step,
switching back and forth each time the button is pressed.
The Toggle IR Code command is an advanced feature. If you have trouble with this
feature, contact Technical Support for help.
To Next Page
Loading...
