Chapter 4: Accessories 35
Accessories
To insert the system into the stand:
1 Insert the system into the stand sleeve, sliding the system brace over the black guide. See
Figure 3.
2 Pull the locking lever forward to secure.
3 Insert the transducer into the transducer holder.
To remove the system from the stand:
1 Release the locking lever.
2 Carefully remove the system by lifting it out of the sleeve.
3 Remove the transducer.
To adjust the viewing angle:
1 Hold the bottom of the sleeve with one hand and turn angle adjustment knob counterclockwise
to loosen.
2 Adjust to desired angle.
3 Turn lever clockwise to tighten.
To adjust the height of the stand:
1 Turn the height adjustment knob counterclockwise and raise or lower to desired height.
2 Turn height adjustment knob clockwise to lock in place.
To Next Page
Loading...
