SonoSite iLook - Cleaning and Disinfecting the Battery

Chapter 6: Troubleshooting and Maintenance 65
Troubleshooting
To clean and disinfect the docking station and stand using the wipe method:
The exterior surface of the docking station and stand can be cleaned and disinfected using a
recommended cleaner or disinfectant.
1 Remove the system, unplug the power supply, and detach any cables.
2 Clean the surfaces using a soft cloth lightly dampened in a mild soap or detergent cleaning
solution.
Apply the solution to the cloth rather than the surface.
3 Wipe the surfaces with the disinfecting solution. Theracide disinfectant is recommended.
4 Air dry or towel dry with a clean cloth.
Cleaning and Disinfecting the Battery
To clean and disinfect the battery using the wipe method:
1 Remove the battery from the system.
2 Clean the surface using a soft cloth lightly dampened in a mild soap or detergent cleaning
solution.
Apply the solution to the cloth rather than the surface.
3 Wipe the surfaces with the disinfection solution. Theracide disinfectant is recommended.
4 Air dry or towel dry with a clean cloth.
Warning: To avoid injury, always use protective eyewear and gloves when performing
cleaning and disinfecting procedures.
Caution: To avoid damaging the battery, do not allow cleaning solution or disinfectant to
come in contact with the battery terminals.
Table 2: Disinfectant Compatibility with iLook System and Transducer
Disinfection and
Cleaning Solutions
Country
of Origin
Type Active Ingredient
Trans-
ducer
C15
Trans-
ducer
L25
System
Surfaces
105 Spray USA Spray Quat. Ammonia U U U
AbcoCide (4) USA Liquid Gluteraldehyde U U U
AbcoCide 28 (4) USA Liquid Gluteraldehyde U U U
Alkacide France Liquid Gluteraldehyde U U U
Alkalingettes (3) France Liquid Alkylamine,
Isopropanol
UU U